Water Pump Installation Instructions.1. Check pump package for following items.2. Remove lower rear panel of saw
3. Remove ignition switch4. Pull ignition switch out and separate white wires
5. Connect bullet clamp-on receptacle to white wire6. Detach hose from blade guard , pull out, and cut approx. 9 in from rear of saw.
7. Attach loose part of hose to outlet fitting of water pump and install pump. Attach ground wire wheninstalling pump to mounting screw.
8. Attach other part of hose to inlet of water pump9. Insert bullet connector into bullet clamp-on receptacle
10. Re-install ignition switch, and install water pump switch. Water pump will be shipped in the off positionwhich is to point down when installed.1
12. Secure loose wires away from drive chain and re-install rear panel.
Comments to this Manuals