Mk-diamond MK-130-3 User Manual download pdf (Page 7)

PRE-START SAFETY

1. When drilling ceilings or walls make sure you will not cut through electrical mains, gas or water

pipes. Use metal detection systems if needed.

2. Before using the machine you need to check the cord and plug. If they are damaged or cut during

use do not touch it, but instantly disconnect from the power source. Repairs should only be

made by an authorized specialist. Take care that the tool is switched off when plugged into a

power receptacle.

3. Unplug and switch the machine off if it is not under supervision, when setting up and

stripping down the machine, in case of excessive voltage drop or when xing or

mounting an accessory.

4. Switch the machine off if it stops for whatever reason to avoid accidental starts.

MK-130/3 SAFETY

SAFETY LABELS

Safety labels contain important safety information. Please read the information contained on each

safety label. These labels are considered a permanent part of your drill. If a label comes off or

becomes hard to read, contact MK Diamond or your dealer for a replacement.

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

No comments

Mk-diamond MK-130-3 User Manual Page 7