Mk-diamond MK-130-3 User Manual download pdf (Page 11)

The water pressure should not be higher than 3 bar.

When drilling “overhead,” you have to control the water at the drill hole by us-

ing a water suction ring and wet-vacuum cleaner for safety.

CAUTION:

NOTE:

WATER SUPPLY

CARE AND MAINTANCE

The machine is equipped with an internal water supply through the work spindle. Using the ball tap

you can regulate the water quantity. The water supply is equipped with a connector for garden-hose

coupling.

If there is a water leakage on the hole of the gear collar, stop your work immediately. In this case, the

shaft seals have to be changed from a authorized skilled workshop.

• The electric tool as well as the ventilation slots always have to be clean.

• During work, please pay attention that no foreign elements get into the interior of the machine.

• In case of failure, a repair has to be carried out by an authorized service center.

Before starting work, ensure the machine is disconnected from the power source. Repairs have to be

carried out only by qualied and experienced personnel.

After every repair, the machine has to be inspected by an electric specialist. Due to its design, the

machine requires minimum care and maintenance. The following maintenance needs to be performed

regularly.

MK-130/3 MAINTENANCE

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

No comments

Mk-diamond MK-130-3 User Manual Page 11